This complete engine oil filter assembly can be installed on all L-4-134 engines. This assembly includes a new Fram type 4" diameter oil filter canister, a 4" diameter drop-in oil filter element kit, two oil canister clamps with special bolts, the oil filter mounting bracket with clamp attaching hardware, three cylinder head bolts, three cylinder head nuts and washers for use with cylinder head studs, an oil inlet hose, an oil outlet hose, the two brass fittings on the side and bottom of the canister and the brass fitting on the side of the engine block.

This oil filter assembly can be installed on the MB/GPW/CJ-2A/CJ-3A/M38/DJ-3A and all VJ Jeepsters, Utility Wagons and Utility Trucks with flathead L-4-134 engine.

FRAM TYPE, ENGINE OIL FILTER ASSY, 4" DIA., INCLUDES THE CANISTER, CLAMPS AND OIL FILTER KIT.

ELEMENT ASSEMBLY, OIL FILTER, INCLUDES COVER GASKET, FOR USE WITH 4" DIAMETER FILTER, WIX USA BRAND.

BRACKET, ENGINE OIL FILTER MOUNTING.

GROMMET, OIL FILTER INLET HOSE THROUGH OIL FILTER BRACKET.

BOLT KIT, OIL FILTER CANISTER CLAMPS TO OIL FILTER BRACKET.

CLAMP, CANISTER 4" DIA., 2 REQD.

SCREW, LOCKWASHER AND SQUARE NUT, FOR FILTER CLAMP, 2 REQD.

MOUNTING KIT, OIL FILTER MOUNTING BRACKET TO CYLINDER HEAD, INCLUDES HEAD BOLTS, HEAD STUD NUTS AND FLAT WASHERS, GRADE 8, YELLOW ZINC PLATED.

LINE, FLEXIBLE, OIL FILTER INLET, 22 1/2" LONG, WITH TWO MALE FLARED ENDS,SWIVEL AT BOTH ENDS, ATTACHES TO TOP OF OIL FILTER AND ENGINE BLOCK IN FRONT OF FUEL PUMP.

 CLIP AND LOOM, OIL INLET LINE TO FRONT ENGINE PLATE, INCLUDES THE PROTECTIVE CLOTH LOOM, 1/2" DIA., WITH 3/8" BOLT HOLE.

LINE, FLEXIBLE, OIL FILTER OUTLET, 9 1/2" LONG, WITH TWO MALE FLARED ENDS,SWIVEL AT BOTH ENDS, ATTACHES TO FITTING AT BOTTOM OF FILTER AND ENGINE TIMING COVER.

CONNECTOR, STRAIGHT, BRASS, OIL FILTER INLET LINE TO TOP SIDE OF FILTER CANISTER.

ELBOW, 90°, BRASS, OIL FILTER INLET HOSE AT LEFT SIDE OF ENGINE BLOCK IN FRONT OF FUEL PUMP.

ELBOW, 45°, BRASS, OIL FILTER OUTLET,  ATTACHES TO BOTTOM OF FILTER CANISER.